HPA00716PWR

595-HPA00716PWR
HPA00716PWR

Fab. :

Description :
Contrôleurs de tension à remplacement à chaud 0.8-V to 16.5-V 1.2A IQ 292-uA Igate source N+1 and OR-ing power rail controller 8-TSSOP -40 to 85

Cycle de vie:
Obsolète
Modèle de ECAO:
Téléchargez gratuitement le chargeur de bibliothèque pour convertir ce fichier pour votre outil ECAD. En savoir plus sur le modèle ECAD.
Mouser ne vend pas actuellement ce produit dans votre région.

Disponibilité

Stock:

Produit similaire

Texas Instruments TPS2412PWR
Texas Instruments
Contrôleurs de tension à remplacement à chaud N+1 OR-ing Pwr Rail Cntrlr A 595-TPS2412 A 595-TPS2412PW

Attribut de produit Valeur d'attribut Sélectionner l'attribut
Texas Instruments
Catégorie du produit: Contrôleurs de tension à remplacement à chaud
Restrictions en matière d'expédition :
 Mouser ne vend pas actuellement ce produit dans votre région.
- 40 C
+ 85 C
SMD/SMT
TSSOP-8
Reel
Cut Tape
MouseReel
Marque: Texas Instruments
Pays d’assemblage: Not Available
Pays de diffusion: Not Available
Pays d'origine: Not Available
Type de produit: Hot Swap Voltage Controllers
Série: TPS2412
Nombre de pièces de l'usine: 2000
Sous-catégorie: PMIC - Power Management ICs
Raccourcis pour l'article N°: TPS2412PWR
Produits trouvés:
Pour consulter des produits similaires, sélectionnez au moins une case.
Sélectionnez au moins une case pour consulter des produits similaires dans cette catégorie.
Attributs sélectionnés: 0

TARIC:
8542399000
CNHTS:
8542319000
CAHTS:
8542390000
USHTS:
8542390090
JPHTS:
854239099
MXHTS:
8542399901
ECCN:
EAR99

LM5060 High-Side Protection Controllers

Texas Instruments LM5060 High-Side Protection Controllers with Low Quiescent Current offers intelligent control of a high-side N-channel MOSFET during normal on/off transitions and fault conditions. The constant rise time of the output voltage results from the inrush current control. Both an Input UVLO (with hysteresis) and a programmable input OVP are provided, with an enable input offering a remote on or off control. The initial start-up VGS fault detection delay time, the transition VDS fault detection delay time, and the continuous over-current VDS fault detection delay time is programmed from a single capacitor. The MOSFET is latched off until either the enable input, or the UVLO input is toggled low and then high when a detected fault condition persists longer than the allowed fault delay time.